NC532I DRIVER

By using this site, you accept the Terms of Use and Rules of Participation. I was able to reset the NIC with an older driver version and now I can manage the adapters again. If you mess up at any point during these instructions, you may have to start over from the beginning, especially when it comes to disabling the NIC in the BIOS and removing drivers. Use passthrough on the c with OA fw ok, passthrough FW is 2. In addition to my first post: I had this problem at my customer and was able to solve it using these steps. Our NICs were previously teamed, and were un-teamed as part during the work below because teaming may have been part of the problem.

Uploader: Tojar
Date Added: 1 August 2007
File Size: 55.28 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 53682
Price: Free* [*Free Regsitration Required]

Proliant blc G6 BSOD when configure nci NIC – Hewlett Packard Enterprise Community

As i think, If i set it disable, the bios wont collect any data about it thus Os wont see… Any idea? Use passthrough on the c with OA fw ok, passthrough FW is 2. Contact Email us Tell us what you think. Google did not help me… Greeting from Germany.

Related Drivers:  EZONICS EZ-306 DRIVERS DOWNLOAD

Because when I nv532i the IPv4 settings for one of them, the other one shows up the Default gateway.

This entry was posted in Uncategorized. I had this problem at my customer and was able to solve it using these steps. October 20, at 8: We experiencing the exact same issue with a nci NIC. July 20, at 8: Where can i load previous version of evbda. Will try nc532k back the old ram, but i think its unlikely this could be the cause, or?

Resolve for me 1 install kb 2 with out safe mode https: By using this site, you accept the Terms of Use and Nc532ii of Participation.

So just left that out, but after WU the drivers seems to be updated. Hewlett Packard Enterprise International. Thanks for your post! As i think, If i set it disable, the bios wont collect any data about it thus Os wont see…. Tried to set another vlan id in the properties for the card and again BSOD.

Un-teaming also simplified matters. All forum topics Previous Topic Next Topic. Kriss, If you are experiencing the exact problem described nc532j, then these steps should work. July 20, at 4: May 7, at 6: Nc5332i 7, at Where can i find cp?

Related Drivers:  KYOCERA ECOSYS FS-820 DRIVER DOWNLOAD

Download and install Hewlett-Packard Company HP NC532i DP Virtual Bus Device driver

Notify me of followup comments via e-mail. I am assuming the driver will work with all relevant OSes. Leave a Reply Cancel reply Your email address will not be published. In addition to jc532i first post: Hi Have installed Windows R2 on a blc G6.

Have installed Windows R2 on a blc G6. The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. April 18, at 3: Hi, thanks for this post. Every try to configure nc53i NIC, diasbling, uninstalling, updating the driver results in a bluescreen, caused by th file evbda.